How and How Long:
- Using ammonia-based cleaner, wipe down pencil holder to remove any dust or particles. If the plastic is new, wipe down with paint thinner for best results.
- Completely tape off any area that you do not wanted painted. A low tack tape is preferred.
- Shake Fusion can for 2 minutes or more.
- Applying in a well ventilated area, hold can 8-10 inches from surface and spray in a sweeping motion from side to side.
- EZ Touch Fan Spray tip can be adjusted to spray vertically or horizontally - see back label instructions.
- Apply a thin coat and allow to dry for 30 seconds.
- Apply multiple thin coats until surface is completely covered.
- Remove tape immediately after spraying.
- Fusion dries in 15 minutes or less, and can be handled in about 1 hour.
- Fusion must cure a full 7 days to become fully chip and scratch resistant.
Approximate project time: 45 minutes.
|